The number on the sidewall is the maximum, not the target. For a rider of 100–145 lb, pumping to that number gives a harsh ride and less grip in corners. This calculator sets front and rear pressure for your actual weight.
Result
Enter your weight and tire width to see front and rear pressure.
How the pressure is calculated
A tire works best when it compresses by about 15% of its height under load. Less than that and it bounces over the surface instead of gripping it. More, and it squirms and risks a pinch flat. The pressure needed for a 15% drop depends on two things only: the load on that wheel and the width of the tire.
wheel load = (rider + bike) × share rear 53%, front 47% (upright: 58% / 42%)
PSI = 153.6 × load(lb) ÷ width(mm)^1.5785 − 7.17
then × setup inner tubes 1.06 · tubeless 0.97
× surface smooth 1.00 · worn 0.95 · wet 0.94 · gravel 0.88
× wheel 700c 1.00 · 650b 1.02 · 26 in 1.03 · 20 in 1.08
+ 0.25 PSI per mm of width above 45 mm
front is never set below 88% of rear
The core equation is a published curve fit to Frank Berto’s tire-drop measurements, the basis of most modern pressure charts. The multipliers are editorial adjustments: tubes need a small margin against pinch flats, rough and loose surfaces roll faster and grip better with less pressure, and smaller wheels have a shorter contact patch.
Why lighter riders need this most
A 28 mm tire marked “max 100 PSI” carries that warning for a 220 lb rider as well as for you. At 125 lb, the pressure that gives the same tire deflection is closer to 50–60 PSI. Riding at double that does not make you faster on real roads. It shortens the contact patch, lets the bike skip sideways over bumps in a corner, and sends vibration into your hands, which is a common cause of numb fingers on longer rides.
When the standard result does not apply
Hookless rims
Hookless (straight-side) rims have a hard limit of 72.5 PSI (5 bar) and require compatible tubeless tires. If your result is above that, you need a wider tire, not more pressure.
Heavily loaded bikes
For touring, bikepacking or a child seat, include all cargo in “bike and gear”. If most of the load sits over the rear wheel, add another 3–5 PSI at the rear.
Mountain bikes and tire inserts
Trail pressure depends heavily on casing thickness, rim width and terrain. Treat the result as a middle value and adjust in 1 PSI steps: lower for wet roots, higher if you feel the rim strike rock.
Your measured width differs from the label
On wide modern rims a 28 mm tire often measures 30 mm. If you have calipers, enter the measured width: it is the width that determines the pressure.
Common mistakes
- Checking by thumb. Above about 40 PSI a thumb cannot tell 60 from 90. Use a pump with a gauge.
- Pumping once a week. Tubes lose a few PSI a day and tubeless setups lose more. Check before every ride.
- Same pressure front and rear. The rear wheel carries more weight, so the front should be a few PSI lower.
- Trusting a mini-pump gauge. Compare it once against a floor pump or a digital gauge and note the offset.
Where to go next
These tools give starting points, not medical or professional fitting advice. Formulas and data sources are listed on this page so you can check the reasoning. Spotted an error? Tell us and we will correct it.
